| 1. | Influence of heat treatment parameters on the structure and property of ni - cu alloyed adi
热处理工艺参数对等温淬火镍铜合金球墨铸铁组织和性能的影响 |
| 2. | Effect of the content of blaster slag and heat - treatment parameters on properties of slag glass - ceramics
高炉渣含量与热处理制度对矿渣微晶玻璃性能的影响 |
| 3. | Effects of the content of blast slag and heat - treatment parameters on the properties of slag glass - ceramics
高炉渣含量与热处理制度对矿渣微晶玻璃性能的影响 |
| 4. | Study on the relationship between heat treatment parameters and microstructures evolvement of new type tc21 titanium alloy
21钛合金热处理工艺参数与显微组织演变的关系研究 |
| 5. | Discusing how to use the artifigial neural network in material analysis , we got a software of the optimizing treatment parameters and found the best parameters of the treatment
通过系统地对人工神经网络技术在材料分析中的讨论，进行参数优化计算机软件的设计，获得了最优化参数。 |
| 6. | By these research work we attempt to sum up two kinds of thermal residual stresses and look for appropriate composites fabrication and heat treatment parameter
通过以上的模拟，我们尝试将两类应力进行叠加，分析材料内的热残余应力的分布并总结出较为理想的复合材料加工和热处理工艺参数。 |
| 7. | 3 . investigation of heat treatment of the alloy shows the optimal heat treatment parameters is following : solid solution under 47ctc in 1 . 5 hours , then water quenched , artificial aging at 120 ?
三、利用正交方法研究多层喷射沉积a1 ， 22si - 3cu - mg合金的热处理工艺，得出合金的最佳热处理工艺为470固溶保温1 . 5小时，然后在120温度条件下进行人工时效。 |
| 8. | Abstract : the change in strength , plasticity and relaxation rate of pc steel strand before and after stabilizing has been analyzed by means of fracture and stress relaxation tests . the effect of treatment parameters and tensile stress on the properties was obtained and optimum parameters of stabilizing treatment were also proposed
文摘:通过对预应力( pc )钢绞线稳定化处理及随后的破断、应力松弛试验，分析了处理前后强度、塑性、松弛率指标的变化趋势，得出了工艺温度、张应力对性能指标的影响规律，进而提出了稳定化处理的最佳工艺参数。 |
